Fireworks perfect as a New Year decoration

Printing parameters:

• material: PLA
• temperature: 195°C 
• speed; 30-35mm/s 
• layer: 0.2mm 
• infill: 25% 
• supports: in one file
• nozzle: 0.4mm

NOTE: the model should be printed slowly due to large angles

The supports are required on the "Base Red" model, the picture below shows where

Assembly instructions: 

• you need to connect both elements "Base" and "Top Cap" 
• screw the elements that you connected 
• screw the “Stick” WARNING: do not tighten too much because you will break the thread for a more secure grip you can use glue 
• put the "Fuse" in place