This is not my model. (Find it here → https://www.printables.com/model/632872-spiral-vase) It took me 6 prints to get this right, so I am sharing my profile, so others don't have to waste material.  The tiny ribs will turn out bad if you don't slow the print down.  Also, if you are using the supertack, do not skimp on the bottom layers… yes it will pull off the bottom if thin.
 

Vase is COEX3D silver

If you want to know about the roses, they are here → https://makerworld.com/en/models/1058221-large-realistic-roses#profileId-1046016 

I used COEX3D blood red for the petals and eSun Pine Green for the leaves.  Use a heat gun to bend the leaves and stem as needed.