This was used to hold a bulb that back lights a lithophane created by https://itslitho.com/

This E12 / Candelabra bulb base was used to hold a "Aiwode 6 Feet Cord Set with Snap-In Pigtail Candelabra-Base E12 Socket and Handy In-line Power Switch,UL Listed US Plug Electrical Lamp Cord,White,2 Pack." https://www.amazon.com/dp/B08TMCXGJ7 that I purchased on Dec 19, 2021.

I drilled/routed a hole in the wood large enough to pass the cord and switch through. Rubber feet allow the cord to feed out the back.

I drilled out the screw holes a little as the #6 x 3/4in wood screws were a little tight, and I didn't want to crack the print.

Creality

Ender 3

No

No

20