Rotating stand for Amazon Fire Tablet with Case or Nintendo Switch. This is a print-in-place piece. Took about 3 hours and 39 minutes to print, but may differ depending on the printer and settings. After printing, I used command strips to stick it to a bed frame.

Creality

Ender 3

Doesn't Matter

No

0.2

20%

Additional Cura Settings
Combing Mode: All
Fill Gaps Between Walls: Nowhere
Initial Layer Horizontal Expansion: -0.15 (Only if stand doesn't rotate after printing)

If stand doesn't rotate after print, you may need to flex the outer part to break any internal binding. Otherwise, set "Initial Layer Horizontal Expansion" to -0.15 before printing.