I like the design by GoAftens as the angle of rest for the phone is perfect! I remix this Hand Phone Stand by trimming off extra areas on Fusion 360. Then increase the infill to 80% to give it back some strength so that when it drops, it wouldn't break easily.

The logos and names are add on, that you can either design or print it off STLs on the net. Or you could try editing it to print it all at one go. I kept mine separated so that I can add colors.

Lastly, all phones + their casing have different thickness. Therefore, you may need to remix or edit the length of the fingers of the fingers will be too short to allow your phone to seat on it.

Creality

Ender 3

No

Yes

0.12

80%

Suggest to print this at the side rather than standing upright. When I printed upright, the Tree Support from Cura couldn't hold the phone "fingers" in place and it broke off while in print.