Who doesn't love vase mode? And who doesn't love Pikachu? So why not combine the two?

This model prints in one continuous extrusion. I joined the parts so there are no islands. Not too pretty but it is what it is. I also tweaked the eyes and the top of the head to try and compensate for lack of support. I failed to go far enough for the head and the eyes need just a little bit more.

I hope to fix these for the next version and I will probably try and close up the open tops of the vase.

Update. Now version v0.2. I did what I could but now I think I've gone as far as I can with this so expect no more updates.

The print pictured is at 200% and took a little over 1.5 hours.

JGAurora A1

No

No

0.15

No

Sliced with Cura