This device is made to make the process of skinning squirrels easier

How to use: 1. take your skinner add a carabineer to the top hole then tie a cord to it, wrap cord around a tree at head level.

2. insert squirrels hind legs into the small holes with the back of the squirrel facing you.

3. cut the front legs off then cut along the back of the squirrel horizontally then pull the side of the hide toward the head to the connection of the head and neck.

4. flip squirrel and insert the head into the large hole then pull the other half of the hide down to the hind legs and cut off the back legs and tail so there is no more fur on the rear of the squirrel.

5. take out the head and cut it off then cook it.

This print is larger and takes time and a good amount of filament!

Operate this file at a slower pace until the printer starts to fill in the first layer or it will fall apart very quickly!