Summary

As soon as I saw this design https://www.thingiverse.com/thing:6446679/files I immediately wanted to make the same box for myself.
I have this tool: https://aliexpress./item/1005005766289653.html
It has different dimensions and I used the step file from the original design to remake the dimel seat. (thanks to the creator of the original design)
However, after printing the box, I realized that I was not completely satisfied with it, so I made some alterations:

• the original latches practically did not hold the lid, I replaced them with fixed ones, a little tight, but reliable.
• there were many holder holes for small diameters. However, my tool is mostly 3.2mm in diameter. Therefore, I widened all the holder holes to 3.5 mm.
• I found out that with my printer I cannot print the original axis with acceptable quality. Therefore, it was replaced with a simple one, and it is fixed by gluing a washer to it.
• I added storage for the abrasive rolls, which was not in the original design.

I was quite satisfied with how it turned out. It would have been possible to print this box on site in one piece, but I did not do this because... printing is already time-consuming.

Everything is printed without supports. After printing it is necessary to remove the supports in the latch.