What is it and who is it for?

A no-hardware-required kit that allows mounting a GoPro on a Begode Falcon. Recommended if you have a Begode Falcon and want to record your rides from a point of view that make them seem much faster than they really are. Results are great, see for yourself!

Installation guide

• Slide the mount plate through the holes in the orange brackets in front of your Falcon.
  

• Push the mount plate as far back as possible and turn it 90° so that the GoPro mounting point is facing forwards and the cutaway is facing up. BEWARE: turning this part requires quite a bit of force since the tolerances are intentionally nonexistent. This ensures that the plate stays secure even without the spacers and lets you test the print's strength before riding. Better break a cheap part during installation than lose a GoPro.

• Snap in the latching spacers on both sides.
  

Recommended print settings

The models are in the correct orientation. The latching spacers need no supports. For the lips on the mount plate use snug supports.
The model was designed with PLA in mind, so if you use something else, you might need to scale the pieces up or down a bit.

I used 15% infill, two walls and 200% line width, which work fine so far with some moderate offroad riding. Mind you I hate my GoPro MAX, so you might want to use higher infill and/or more walls.

Troubleshooting

1. I can't complete step 3 of the assembly!
   
   It is intentionally hard so that the mount plate stays secure even if the spacers break or fall off. Use more force.
   

2. My GoPro doesn't fully latch in place!
   
   Scale down the plate just a tiny bit. In case you already scaled it down so far that something else went out of whack, shoot me a message - I'll try to correct the model.