Updated to a newer version here: https://www.thingiverse.com/thing:2894679

This model (V1) is easier/quicker to print and is light weight but the joint tend to loosen overtime.

---

A mic arm addon for K7XX (should also work with some other models) with some degrees of movements.

require 3 or 2 M2 screws and maybe nuts

(2 Screw needed if upward hinge is not used, 6mm M2 if you require no nut and 8mm M2 if you do)

Please note:

It will scratch the plastic where the clip holds on to the headphone. You might be able to get away with it by printing it smaller and breaking away the inner side of the clip before clipping it on, but that will not be as secure.

This will work on either side of the headphone. I suggest to put it on the side with the headset wires and twist the mic wire with the headphone wire so you don't have 2 wires hanging down.

Quick tip, buy cable sleeve and tidy up both cable. see pic

Category: Audio