This is a simple, clean mounting bracket designed to hold a Raspberry Pi (in its case) securely near your 3D printer.

I created this to tidy up my OctoPrint setup and keep everything mounted in one place instead of having the Pi sitting loose on the table with cables everywhere.

🔧 Features

• Designed to fit a Raspberry Pi inside a standard case

• Open side to allow airflow from the case fan

• Large side cutouts for easy cable access

• Clean, minimal design that looks good mounted

• Secure fit while still allowing easy removal

🧠 Use Case

I use this mounted to the side of my printer table to hold my OctoPrint Raspberry Pi.

It keeps:

• Power cable out of the way

• USB connections clean and accessible

• The Pi elevated and protected

This is especially useful if you're running an always-on OctoPrint setup and want something more permanent and organized.

🖨 Print Settings

• No supports required

• PLA works great

• PETG recommended if printing in a warmer environment (garage, enclosure, etc.)

Suggested settings:

• 0.2mm layer height

• 3–4 walls (for strength)

• 15–25% infill

🔩 Mounting

• Designed to be mounted with screws through the rear holes

• Can be mounted to:

  • Table legs

  • Walls

  • Printer enclosures

📸 Notes

• Designed around a Raspberry Pi in a case with active cooling

• Make sure your case dimensions are similar before printing

• Cable clearance is built in, but orientation may vary depending on your setup

👍 If You Like It

If this helped clean up your setup, feel free to:

• Post a make

• Leave a like

• Share improvements