These are an alternate version of my openGrid Lite Multiconnect Snaps, using a non-rotating multiconnect instead of the standard round connector.

The openGrid models included Multiconnect snaps with a threaded snap and a screw-in multiconnect connector. I made these simple snaps have the multiconnect connector as part of the snap. There are 2 different snaps, one using the standard snap (pushes straight into the openGrid tile) and one using the directional snap (an arrow on the back indicates the side that goes in first). These were made from the modeling files that David D provided with the openGrid and Multiconnect frameworks. The directional snap is based on the v2 directional snap.

My test prints were done in PLA with 3 walls and 15% gyroid infill.

These are the openGrid Lite version of my openGrid NonRotating Multiconnect Snaps.