Surprisingly, it's quite difficult to find a good sink strainer. I was looking for something that could be placed in the drain hole

The trick to printing this filter is to use the fill mode of slicing software to create a grid. Print with three to four edge lines, without solid top and bottom layers. Then adjust the fill density and mode to obtain the desired grid effect. For me, I used a 45% triangular fill pattern. The grid is printed as a beautiful, fine single-line wall, and the printing speed is also very fast.

It is designed to fit the drainage holes of American standard kitchen sinks

Print settings

Printers:

AUDIO

Base:

None

Support:

None

Resolution:

0.2mm

Fill in:

45%

Remark:

Category: Kitchen and Dining