Updated with a few more gussets and braces for more crash resilience and no washers required between camera and frame.

This is a caddy for a tiltable flight camera for a mini quad. (250 size)
will suit 30mm standoffs and higher.
This one has a small footprint and a vertically mounted (7g) servo.
Uses a mini camera like Surveilzone HS1177 (PZ0420M) Sony Super HAD II Ultra Mini.
use an output from your receiver to drive the servo or output from your Flight Controller

print at med/best quality 5% infill
30mm standoffs minimum height.
5-9 gram servo required
created for small footprint leaving room in frame.
you will need to attach your servo rod to your camera on the side if you are using 30mm standoffs.

If you are using a HS1177 mini cam - simply drill out the holes in the side lobs the same size as the cameras locating lugs (where it screws to the frame) this will give you a nice pivot point. and the screws supplied with the cam fit nicely.