If you (or any of your friends..) are into MIG welding and like me always look for a handy place to park the handle between welds, this may be a useful solution...

The holder is printed in two parts to reduce the supports, and also it make it easier to replace one part if needed.

The base has recesses for gluing four 12/3mm magnets. On a flat steel table/surface this should provide sufficient hold of the holder.

An optional table clamp is offered. For this you will need the printed part and a right angle bolt and wing nut (M8 or 5/16")

The table catch part should be printed with 80% infill.

Happy welding... (: