I designed this tool to easily achieve precise leveling of the X-axis gantry of the CR-10(s).

Over time, the gantry may tilt due to the stepper motor being out of sync. Simply place the tools under the gantry on either side of the printer, loosen the set screws on the motor coupling, and gently press the gantry down onto the tools with your hand. Then, rotate the screw rod to allow the gantry to settle smoothly into place and retighten the set screws. Finally, lift the gantry and remove the tools.

Please remember to take out the tools—otherwise, the gantry will not be able to descend normally.

If you print this design, please record the materials used and take a quick photo to upload it. We also welcome you to share your experience of using it!

Best wishes to you,

Rich

Editor: December 10, 2018

The V3 version has now been uploaded. It has a groove added to the bottom, which makes it easy to use the tool in conjunction with the plastic trim installed on the profile.