Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 4.6mm

Filaments Used:

PLA BambuLab Tough Black Transmission Distance: 0.6

PLA BambuLab Matte Ice Blue Transmission Distance: 3.5

PLA BambuLab Basic Jade White Transmission Distance: 5

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Silver Transmission Distance: 0.5

This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #15 (1.28mm) swap to Ice Blue

At layer #24 (2mm) swap to Jade White

At layer #31 (2.56mm) swap to Black

At layer #33 (2.72mm) swap to Blue Gray

At layer #41 (3.36mm) swap to Jade White

At layer #45 (3.68mm) swap to Silver

At layer #48 (3.92mm) swap to Jade White for the rest.