Case for DIY LCD 1602 display device
Rosamund Hickman
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2024-09-19 05:39:15
0
0
000Описание
Источник модели
Отзывы(0)
Summary
Widened a bit to allow extra wires etc to fit a better. Also removed supports for arduino and breadboard as they were not needed in my use case.
Original on top, modified below.
If printing again, I'd make the bottom part about 1mm wider and 0.5mm higher to fit more tightly.
Printed on Anycubic PLA with Anycubic Kobra 3 on standard speed/settings.
Print Settings
Printer Brand:
Anycubic
Printer:
Kobra 3 Combo
Supports:
No
Infill:
15%
Источник модели
Оригинальная ссылка: Посмотреть детали
CC BY-SA