Summary

Summary
I got a great roll up tool bag for Christmas. It has 4 long compartments 2 small compartments. Each with zippers. The only problem is that I know I’ll forget what’s each compartment.

Enter the Tool Logo Zipper Pull. I print these in PLA with a filament color change command (M600) after the inner flat is finished to highlight the tool and border. (Layer 10 on my Creality S-1 Pro) I then added small key rings and attached them to the bag. So far, I have:

• Wrenches
• Pliers
• Flashlights
• Magnets
• Electrical Tools
  and
• a blank

They are 1 inch from point to point and just over 4/5th of an inch from side to side. They should scale up well. I doubt they will scale down much.

Print Settings

• Rafts:No
• Supports:No
• Infill:25%

This is an original design. I’d be happy to make more based on requests. No charge.