Here is my submission for the Thingiverse & Atomstack design challenge. Designed fully from scratch in Blender, this LED desk lamp offers both style and functionality to your workspace.

2x M3x8 Hex Screws
5V LED Strip Light - https://shorturl.at/94dDb

1. Screw both legs into the rear holes on the case using two M3 screws.
2. Feed the LED strip through the back of the case.
3. Expose the adhesive on the LED strip and mount along the inside of the case.
4. Cut off any extra length from the LED strip. Make sure to cut on the marked lines.
5. Attach the logo plate onto the front of the case using a few drops of super glue.

Installation Video: https://vimeo.com/1019318547?share=copy

~Case~

Infill: 0% (Not required and decreases print time)
Layer Height: 0.28 (Design does not require a high resolution)
Bottom Layers: 3 Layers

~Legs~

Depending on your slicer, the legs may need to be rotated to lay flat. I needed to rotate mine 90 degrees in Cura.

Infill: 20-40% (Allows for more or less flexibility)

~Atomstack Logo~

I suggest rotating this 45 degrees in your slicer to get the top and bottom later lines to run parallel with the logo. This creates an overall nicer and less busy aesthetic when light is passing through. * I show an example of this in the photo below

Layer height: 0.2mm
Infill: 100%