A little case for the Qorvo DWM1001-DEV Development Board. Check the list below for compatible boards.

The board should sit quite firmly in the case itself and is held down by additional screws.

Recommended Material & Print Settings

• Nearly every Material should work, Test prints were done in PLA.
• No supports needed.
• Two (or more) perimeters recommended for the screw pegs to be solid enough

Additional Hardware

• 3x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
• 3x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)

Compatible Boards

• Qorvo DWM1001-DEV
• Possibly others?

Please consider liking the model and posting a Make :)