Summary

Notes and updates:

Note: My apologies, I didn't include the notches for the M8 bar/nut. I'll try to get to that soon and re-upload.

Note: Okay, I uploaded new files, where the foot width were 25, not 30. I included a cutout for the M8 nuts.

Feet!

These are feet meant to be printed with flexible filament like Ninjaflex. Print it as hollow as you can muster, like 15-20%.
It should fit the Skeleton3d lower corners.

I made this because my printer wasn't perfectly square which would cause it to rock opposite corners. Also this was an attempt to try to isolate the insane amount of vibration transmitting into my table.