I was bothered by the fact that the TROFAST drawers easily tip out of the guide when pulled out.

These small stabilizers give the drawer additional support.

The parts are symmetrically designed and can therefore be used on the left or right without mirroring in the slicer.

There are two versions:

1. Outer wall version: one central screw hole.
   
2. Inner wall version: two screw holes.
   Only one screw is used per part, allowing the screws to be placed alternately on opposite sides without getting in the way inside the cabinet.
   

For countersunk screws with a head of Ø 6.8 mm × 3 mm deep.
Screw: Ø 3.5 mm (e.g., wood screw)