Suitable for 20mm-thick steel mesh templates. Since the thickness of such steel meshes is usually 21–22mm, a gasket is provided. Simply apply a small amount of quick-drying glue, and the gasket can be easily fixed in place.

The dimensions of the mounting holes are as follows: the distance from the center to the rear end is 160mm, and the distance from the center to the front end is 30mm. This design is optimized for M5 hexagonal countersunk bolts. It is recommended to fix this component on plywood to achieve high-precision, large-scale mass production. In addition, I also recommend making an alignment jig for the PCB - just prepare three spare PCBs with consistent thickness and fix them in a U-shaped layout, so that the PCB to be printed can be sn

This design is suitable for a 1.6mm-thick PCB. If you need to adjust the design to fit a thicker or thinner PCB, please set the installation hole spacing to: [the desired PCB thickness] - 0.2mm.

At the same time, please make sure to raise or lower the white bracket to a suitable height according to your actual needs, so as to ensure a perfect match with each fulcrum.

This project requires the installation of four M5 thermoset inserts and five M5 bolts. It is recommended to use bolts with a length of 15mm.

Please print according to the following instructions:Increase the wall thickness appropriately, adopt a high filling rate, and select materials with high strength and good rigidity. Ideally, carbon fiber reinforced materials can be used.Otherwise, under the action of the clamping force, these clamps are extremely prone to deformation or bending.