Was cutting a small stack of papers with a Zutter Bind-it-All (http://www.binditall.com/Binditall.html)

While trying to cut the ends of the 11" long paper it became difficult to keep everything straight in the cutter so I modeled and printed this support to make hold the opposite end of stack of paper as I was cutting out the binding holes.

Print Settings

Printer Brand:

LulzBot

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

Lowest your printer can handle and still make good parts

Infill:

Notes:

Rotated for Thingiverse Screen Image.

Place on bed sideways so no support is needed. Layer height was .35mm on a .5 nozzle.

5% infill and wall thickness was 3 layers.

Went for a fast print because detail doesn't matter - was going after functionality.

How I Designed This

Groove height matches Zutter Bind-it-All hole cutter height.

Groove thickness matches Zutter Bind-it-All hole cutter spacing.

Category: Hobby