Designed for this tiny FPV camera: https://www.amazon.com/gp/product/B01LYAW6S6

...and tested to fit on the QX95 quadcopter stock frame.

I broke 2 previous FPV cameras for my QX95 by (1) hitting a brick wall, and (2) hitting the ground upside-down too many times which both broke the antenna off and caused the back of the camera to hit the frame and broke a tiny coil off.

This camera protector case is intended to prevent the camera from flopping backwards and hitting the frame, prevent it from being smashed if hit from the front (brick wall), and also protect the antenna with a stalk going up next to it.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/kY4ILaOa7xN

Monoprice Maker Select v2

No

Yes

0.1mm

20%

The supports are for holding up the cutouts on the sides that are for a rubber band to go across and hold the camera/case down.