A tripod for your phone so you can take videos or long exposition pictures.

There are 2 different legs, short/long.

There are also 2 different holders. One uses m3 screws/bolts and you will have to print the stops so the hardware does not damage your phone or cover and the other one uses the plastic screws. For both of them you will need supports.

I printed everything in PLA with 3 shell layers (1.2 mm total, 0.4mm x 3).
I printed the screws with 100% infill and the holder with 50%. The legs, stops, and the base can be printed with 20% infill.

If the printed screw goes to tight try to scale it XY 0.99 or 0.98.

You will need three m3x10 hex bolts for the legs and one m3x16 for the holder.
If you decide to use the holderHW you will need two more m3x16.