This is a basic mount for the BL Touch to be attached to the original E3D clamp made by Tech2C (clamp provided).

The mount is a simple design to just bolt onto the "fan" mount of the clamp. The fan mounts aren't used in the case of the hypercube as it uses a blower fan packed behind the hotend rather than next to the hotend.

Just use a few M3 nuts and bolts to hold the mount to the clamp and then again with the clamp to the main X carrage mount. Use a few M3 nuts and bolts to hold the bltouch in a fixed position.

Theres a small cutout on the part to pass the cables through from the bltouch to the top of the mount to allow you to plug them in.

Tech2C: http://www.thingiverse.com/Tech2C/about