A replacement for the plastic SmartKey clamshell used in Morse Watchman KeyWatcher. Had one break at work so I grabbed the iButton out of it to make a replacement. I paused the print around 6mm to slip the iButton into the new print. The pocket on the original was much looser, and from what I've seen that's to allow for the chip to rotate as it is inserted and removed to "prevent wear". I made the pocket a little bigger on this version since the last one was a little snug, but haven't tested it out yet.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Notes:

Pause the print at 6mm to put a 1990r-f3 iButton in it. I didn't but just slipped it in somewhere around 4mm while the extruder was down at the other end and everything worked out for me, but you know, be careful I guess.