I wanted to remix this cover as the original design kept popping out when the wires pulled upwards (build plate returning to the home position for example).

This design incorporates a lip at the bottom and as such is best printed in TPE / TPU to allow a bit of flexibility to fit. Once installed its a snug fit an going nowhere :)

The internals & capping section (that allows the wires to pass through) does not now require any supports also due to the chamfering. Just a small amount of support advisable for the perimeter to ensure the lip is nice and accurate.

Will share my basic settings in the section below as had a lot of trouble printing with TPE until these were dialled in...now printing very well :)

Print Settings

Rafts:

No

Supports:

Resolution:

0.25

Infill:

Filament: Technology Center TPE Black

Notes:

Category: 3D Printer Accessories