These are the parts necessary to install a Tippmann response trigger in the mechanical frame for the X7 Phenom/MCS Hurricane.

This has been successfully tested at 20 bps with a magfed Hurricane and round ball.

I have not gotten it to work properly with X7 Phenom. The RT function works but the cyclone doesn't seem to get enough air. Might be a fun project for someone to tinker with.

It does work with the air tube in the grip.

You will need:
1x Tippmann 98 response trigger
A drill with 1/4" drill bit
A hack saw (the cylinder and pin of the RT are too long and will need to be shortened)
A set of needle files
A dremel (not required but it would be nice).

Installation video can be found here.
https://youtu.be/0CaB5lZ8ceY

Creality

Ender 3

No

Yes

0.12

25%