This is case for UnAmiga. I didn't like having bare electronics exposed so I went on making printable case. This was the result.

I uploaded two main versions, one is normal case, and the other has pads on corners. I sometimes have issues with corners lifting, these round pads on corners are someting like brim, but not on the whole print, and they seem to help. After print I just cut them off.

For top I also included clean version so if anyone wants to use their of simbols, or simply wants clean version, can do so.

Button shafts are made so they go over their respective buttons.

Depending on plastic color and density power LED might be visible through the case. In my case. Plan is/was to print button shafts with transparent plastic so LED would shine through it. But unfortunately currently I don't have any clear transparent filament on hand so I settled with same plastic as case. I tried with blue PETG filament I have, but it's too blue for LED to shine through in any meaningful way.

As for LED that shows HDD activity I left small hole above it. Diameter should be right about 1.75 mm so filament string can pass through it. Plan is to put piece of clear transparent filament string through the hole, that will go to the LED on PCB so LED light is passed.

TEVO

Tornado

No

Doesn't Matter

0.2

15%

Supports are recommended on screw holes of bottom part. I printed it that way, I suppose they'd print messy if printed without them.