A couple of the supports have been broken or lost and it seemed like something fun to try and reproduce. The shape was much more complex that I though and I spent way too much time on it but it worked.

The original part has a pocket to stow a car that I did not reproduced but it would be fairly easy to add as I still have the FreeCAD project.

Anycubic

Photon

Yes

Yes

0.05

No

I had quite a few failed prints with this part. Lot of support and over baking the piece (2 seconds per layer) helped.

A filament printer would probably do a much better job at printing this but I don't have one handy at the moment.

• I traced the piece on a shape of paper and measured the angles with a protractor
• Used a digital caliper to measure all the lengths
• I took a picture of a remaining piece
• I used it in FreeCAD to get a rough shape of the piece.
• Spend way too long learning / fighting with FreeCAD
• Print->Modify->Print