This is the beginning stages of a major overhaul of the OneUp 3D Printer.

Print both a front and a back piece, then replace the original bed mount with these parts. I will upload better pictures later.

If you do not have a long enough belt to fit into the M3 belt clamps, you may need to find a source for longer belt (or replace the current with a GT2 belt and pulley [prefered]).

You will also need zip ties to attach the linear rods.

I printed these parts on my OneUp at a 45 degree angle to make them fit on the print bed. These parts are currently being used on my OneUp printer.

Doesn't Matter

Doesn't Matter

200 micron or better for detail

20% or better, 30% prefered

Print with the long flat side down, with the belt clamp up.
If your printer prints easily removable supports, you may try that, however I found it not needed as my printed bridges easily enough.