The Slallenium Slalcon is remix of the Fillenium Malcon (fixed) remix. Thingiverse is not finding the remix sources, I will update that later if the bugs get worked out.
For now, I remixed from https://www.thingiverse.com/thing:2338105
The base is remixed from https://www.thingiverse.com/thing:781328
The joining cap and peg joiner help out. I glued the cap into the base of the printed SS with trihole and then use the joiner to go to this excellent peg which is not included with these files: https://www.thingiverse.com/thing:3696406.

What did I change?

1. The cockpit was gutted of the seats, bulkhead etc and the windows were completely reworked for SLA printing and painting a model that would work with the X-Wing board Game. The model has been scaled to 1:270.
2. The gun turrets were filled in.
3. The rear engine section of the malcon was restored.
4. A triangularish (pie shaped) hole was cut aft of the ventral gun turret. This accepts the large standard pegs. However. I wanted something a bit more stable after printing and so designed the cap and joiner to go with an excellent peg system that I found on Thingiverse. I had to remix a base to go along with it.

Where to go from here? I hope someone, or me at a later date, remixes again to add more greebling. I am happy enough with the original and it does print very easily with not much support work. Adding more complex greebes will likely make the print more challenging, but would raise the game.

The Slalcon and cap were printed SLA of course. Supported using Chitubox.
Base, peg, and joiner are FDM. The joiner was printed with supports on the plate.