Give your drawer or door, Butterfly Vibes!

You Need:

Cute Colours (Pla or else)

one M3 x 3mm or M3 x 5.7mm heat set

two strands (approximately. 6cm) of 1.75mm Filament in your chosen colous

Print Instructions:

Filament : Pla or else In nice coulours.

Eyes and mouth i.e. in black

I recommend the 3.MF files so you can give the Butterfly additional Pattern in it wings.

Support: 

Main Body can be printed with supports, I recommend a pause before the Support gets “overprinted” and colour in the support with a marker for an even easier support Removal. 

Assembly:

Glue in eyes, and wings

then take a Filament and insert it with a little bit of gloop into the head or add the antennas beforehand

2-3 cm of Filament (1.75.) should do the trick, just make sure they have the same lenght.

Use Petg, abs or maybe even Nylon or TPU, to make them a bit stronger for the little hands.

melt in the m3 heat set insert after you added all wings. (lenght m3x3 and m3x5.7 should work [designed for 5.7])

If you have Children who are 4 years or younger, I dont recommend to add the antennas right away, as they are quite easy to break off, and are hard to replace unfortunately.

You might also want to check out other Knob's:

Koala Head knob:

printables:1373713

Racoon Head knob:

printables:1376555