I wanted to put a gridfinity insert into the IKEA Hemnes Sliding Drawer but the length and width of the inside of it are not suitable for gridfinity, thus I created an insert to fit a 2x7 gridfinity insert. I modeled it off of the Gridfinity Magnet Light Baseplate by @RIP_PloKoon but I have not tested it with other gridfinity baseplates so keep that in mind.

I have found that the exact dimensions of the drawer insert are not consistent, thus you will have to undo the screws slightly and push the sides closer/farther apart to fit.

Recommended specs:

 - 0.20mm

 - 2 perimeters

 - 0 top and bottom solid layers to have the infill show through