Headphone holder based on, and inspired by McAbra's Mirumee Headphone Holder. 

If you print it. Please post a comment or photo, any feedback is appreciated. Don't be shy!

IMPORTANT NOTES FOR SLICING:

1. Please scale the Headphone_Holder_Arm down to 99.8% (uniformly) for an easier time fitting the arm into the clamp. 
2. Make sure to enable “Print Thin Walls” (in Cura) or an equivalent setting or else the center section of the arm will not print as needed.
3. Reorient your Arm and Clamp parts as seen below. 
4.  
5. No supports are needed.

-The arm can be reversed in the clamp, I've never done so, but the option is available. 

-The pics of the multi colour and all white holders are of slightly outdated models, I've since added a few extra chamfers. 

While I really liked McAbra's design, I needed my headphones to be above my desk height and easier to grab. And so I remixed the clamp portion of McAbra's headphone holder to receive the raised arm which slots into place and raises the point where the head phones are hung to be above your desk.