A holder for your extra rolls!
Never again be without TP!

Print instructions

This is a very easy print but a time "hungry" one!
There is no need for supports.
The center column can be printed layed down (to the flat side) or upright (if your z axis fits it since its 210mm)
The cover is printed upside down.
0,3mm layer height and 25% infill.
You will need two screws to mount it on the wall!
I used 4.8mm phillips screws with 6mm wall plugs.
The picture is from v1. For the v2 I added small "windows" to see if there is TP inside and made the print support free.
It can hold 2 extra rolls of TP.