This is a small, quick printing, magnetic pickup tool that is designed to fit within 58mm portafilter baskets.

This tool works best when paired with a magnetic puck screen, like the one sold by Sworksdesign, however I've had a good experience using it with a less/non-magnetic screen placed on top of a Sworks screen,

like this:

------------Magnetic pickup tool------------

---------Non-magnetic puckscreen---------

----Sworks magnetic puck disc screen----

It's designed to work with Harbor Freight rare earth magnets (found here), but should work with any 8mm diameter / 2mm height magnets.

Should be able to print without any supports when oriented with magnet holes on print plate. The magnet holes are designed to be friction fit, but depending on your printer + which magnets you use, you may need to use a bit of glue. The holes are also designed to be slightly more shallow than the height of the magnets to allow for better contact.

Four magnets was the optimal grip to ease-of-removal balance for me, but the middle hole can be left empty for a weaker hold.

There is currently no 54mm basket version, but I can modify if there's a request for one.