This is the mount I created for the E3D Toolchanger and EIBOS Artemis Extruder in a direct drive config. Currently this would work for To & T1 without other modification to the existing printed parts.

This replaces the V6 Receiver Top and uses the same hardware to hold the mount down, you then use 4 M3 10mm bolts to hold the Artemis to the mount. The wire strain relief mounts to the side with the M3 set screw. 

I created this mount with the used of models from both kswaid (Thingiverse) E3D (Printables), so thank you too both sources.

Print settings:

.2mm layer height
3 walls
40% Infill
I used PLA filament
Prints without supports