Basic case for the Raspberry Pi 4.

The Raspberry Pi is made for M2.5 screws; However, this design uses M3 screws. M3 Screws can be used with a Raspberry Pi, you just have to kind of drill them into the screw holes. This feels wrong but it will not damage the electronics.

Supports recommend on the case top, only for the screw holes.

BOM:

• 4 ea. M3x25 screws
• 4 ea. M3x10 screws 
• 8 ea. M3x4 heat set inserts 
• 1 ea. Fan: Recommended

Tools:

• Soldering iron (for heat set inserts)
• 2.5mm Allen key/hex screwdriver