This is a tilting enclosure for the Seeed Studio MMWave Lite radar module (https://wiki.seeedstudio.com/Radar_MR24HPC1/) with a base that can hold a microcontroller like an ESP8266 D1 Mini.  

Printing Notes:

This is designed to be printed in PLA without supports. There is an overhang when printing the base that contains the hinge but it's been designed to be relatively printable without any sagging. The base lid needs to be printed so that the lid tab is facing up so make sure to flip in upright in your slicer!

You'll need the following hardware to assemble everything:

1x 12mm M3 bolt (for the tilting hinge)

1x M3 nut (for the tilting hinge)

3x 5mm M3 bolt (for sensor box + MCU control box)

4x 4mm M2 bolt (MMwave sensor mount) - you only really need 2