FPV canopy for Eclipson Model S. Designed for DJI O3 unit, but any vista should fit too.

Features:

• 9g servo mount for pan
• holes to zipties
• O3 antenna mount
• Secure canopy in place using M4 bolt

Pan tilt system is not included. Camera mount is not included too!

How to print:

• !!!! USE BRIM !!!! or canopy can detach from build plate mid print. Contact surface is very small.
• Orient both canopy pieces so they stand vertically.
• No supports needed.
• Print both canopy pieces with your eclipson A/LW profile (single wall, no infill, 1 top 1 bottom layer)
• Print holder.stl with 3 walls, 30% infill, 3 bottom 3 top layers. Make sure its bottom surface lays flat on the build plate!

I used esun PLA+ for all canopy pieces but you can use any filament you want. For O3 air unit, i would recommend using something that can resist its high temperatures.