This a replacement for my glovebox catch in my rx7 that i lost. It has slots to adjust where the door stays closed. It works well and the door now opens and closes like normal.

I printed in petg for heat resistance.

I have two models available:

The long one is what is shown in the picture and is what i used. The bolt slots are a bit too wide and needed washers and it has unnecessarily long slots for adjustment.

The short one is untested but i figured that i would try to fix those problems for anyone that would want to try it. If it doesnt work please let me know, but it should save some print time and material and make it easier to install.