This is my first official design!

I wanted to mount my Alienware Alpha on the wall in my garage with the rest of my equipment, so I searched for a wall mount and couldn't find one I liked. The Alpha pulls air from the bottom and vents out the rear so I needed to leave the bottom exposed. I tossed a VESA mount on it (as close as I could get to a VESA Mount) With the 5mm Thick walls you could actually suspend this from under a desk if you wanted. I tested it and it seemed super sturdy.

Enjoy!

Tronxy-XY3

No

No

.32mm

50

I Printed this with Green Hatchbox as well, both printed very well with no supports.