Small enclosure for the Waveshare Barcode Scanner Module

Lid is snap fit, so you it can be a bit hard to take off ones first assembled.

This case assumes you trigger scanning using commands as there are no physical access to the trigger button on the board when the enclosure is assembled.

Printing instructions:

Print the lid with the top down and the bottom with the bottom down. Supports might be needed for the holes on the bottom side of the case depending on the printer.

The model in the picture is printed on a Bambu P1S with:

• Filament: Bambu PLA Basic
• Infill: 15%, Gyroid
• Supports: No
• Adhesion: No