The Among Us figures I made for my former students.

I really should stop doing sidequests lol however my former students mean alot to me and I expedited this to the top of my list because this will likely be the last time I will see any of them in person.

Kinda how it goes with teaching as students get older but for me also I completely moved away from the teaching field (was a side gig I had)

Im gunna miss the back stabbing ❤️

Started by modeling out the figure in 1 solid piece with Solidworks.
Then took a look at it in Bambu slicer to see how the model rendered in Color.

Then I went back into Solidworks and made 3 models using the original whole model and Extrusion cuts to isolate the Body, Visor, and Knife into seperate models.

Did several test prints to check tolerances.

Attached models are the final versions, exported from Bambu-slicer after scaling down.

Note: Knives were printed over-sized and then manually cut to fit into the knife slot. This could be refined: update pending