Shower head holder bracket for my shower head on a hose kept breaking. (grandkids, Lol) I designed this kind of a cast that easily slips over the top lip and supports the shower head. My settings are as follows:

Shower head holder mod to support the sides of the shower head bracket / holder as they split after a while and spread allowing the shower head to fall from the holder. This Mod simply slips into place and lips on the back side and covers the front of the holder creating a cast that will hold the sides of the holder in making it stronger and holding the shower head. I printed this holder with the following settings in CURA

Layer height 2.0

Speed 60ms

Nozzle 210 c

Bed 60 c

Infill 10%

Walls 7

Top and bottom 6

Supports None

Printed with Sunlu Silky Silver

Some shower head holders may be a little wider at the bottom and this mod has 2 nipples inside (one on each side) near the bottom. These can be trimmed out to make it loser at the bottom. All the holders I have run into that hold the hose, this should fit

Category: Bathroom