After watching Devin Montes of Make Anything create an awesome lock puzzle.

Check them out here: https://www.myminifactory.com/object/3d-print-lockpick-puzzle-10-74862

I got inspired to try to make my own, only a little more challenging. So I bring you Bust-A-Lock. (tropic thunder anyone?)

This can be solved quickly if you are lucky or it can take a while... I have also included a 2d mapping of the maze so that if you do get stuck you can use it to solve the puzzle, dont give up too quick!

Must be printed 0.15 layer height, gently twist key to separate from the body.

I Included a KEY just in case you break it in a fit of rage. Not required to be printed.

Make sure your printer has good dimensional accuracy and dont over squish your bottom layer. Tolerances on this model are small.

EDIT Added another puzzle! has a 2 stamped on it so you can tell the difference. Any additional puzzles i add will be marked with a number.

Print Settings

Printer:

Prusa MK2

Rafts:

Supports:

No

Resolution:

Infill:

10-20% material dependent

Filament:

FoxSmart PLA/PETG

Yellow

Notes:

Category: Puzzles